VT1100-SABRE.org

Make your bike more visible from the back by making your turn signals function as running lights also.

Originally posted by psychocircus on The Sabrehood

Parts List

• stock front turn signal guts
• red lenses for the rear running part: kurys dish bezels are the cats ass for this!
• 1157 bulbs
• 1 male bullet connector
• 3 female bullet connectors
• 9" 18 gauge wire cut into 3" sections
• some heat shrink tubing

Instructions

1. make a 3-way splitter for the extra wire from the stock turn guts.
2. swap the guts from the rear signals to the fronts
3. plug the splitter male into the brown female plug in the rear turn housing.
4. plug the male brown into one of the splitters female plugs.
5. run the green wires to their green plugs.
6. run the solid blue/orange wires to their connections
7. run the blue/orange wires with the white stripe to the remaining female plugs on the splitter.
8. replace the single circut bulbs with the 2 circut bulbs
9. test the new setup to make sure there is no loose connections, button up the rest cause yer done!